Product Range
Power Electronics & Drivers Lab

Single Phase AC
Voltage Controller
1 Phase
Cyclo Converter
1Phase Dual
Converter Firing Unit
1Phase Half
Controlled Converter
1Phase
Inductive Load
1Phase Isolation
Transformer
1Phase Electrical
Resistance Load
3Phase Electrical
Capacitance Load
3Phase Electrical
Resistance Load
Back View of Power
Electronics Trainer
3Phase of Control
Bridge Converter
DC Jones
Chopper
Differential Module
(2Channel)
UJT, R&RC
Firing Circuit
Forced Commutation
Circuit
McMurray Bedford
Bridge Inverter
Series
Inverter
Side View of 1 Phase
Electrical Resistance Load
Side View of Power
Electronics Trainer
Single Phase
Dual Converter
Single Phase
Dual Converter
1Phase Dual
Converter Firing Unit
1Phase
Inductive Load
UJT, R&RC
Firing Circuit
  • Power Electronics Lab

The HiQ make Power Electronics Trainer Kits provides extensive training in the principles of  SCR control circuits. The trainer modules can be used as the basis of a programme,  Starting with the principles of uncontrolled rectification to simple control using SCRs, then progressing through Single and Three Phase controlled rectification with their associated firing requirements.

The characteristics of various loads also can be  studied including inductive and resistive under half and full wave, single and three phase rectification, both controlled and uncontrolled.

All the Trainer kits Are supplied with 25A. SCRs with dv/dt and di/dt protections, MCBs and fast blowing Fuses are provided to protect the devices from the short circuit, overload and miss-application. And each unit is having a built-in Firing Circuit and a soft start switch.. The  Circuit diagram printed on the front panel and the  test points are provided on the front  panel  and terminated them on a 4mm binding post terminal cum socket. To facilitate the user to construct the circuit and make the interconnections by use of patch cords and  to measure the readings & verify the results on a cro.

  • HiQ5101 Study of SCR,UJT,TRIAC, DIAC , MOSFET & IGBT
  • Charecteristics  Trainer
  • HiQ5102 Study of Firing Circuits Trainer using R&RC and UJT
  • HiQ5103 Single Phase AC Voltage Controller  
  • HiQ5104 1-Phase Half Controlled Converter  
  • HiQ5105 1-Phase Fully Controlled Converter
  • HiQ5106 1-Phse Dual Converter
  • HiQ5107 Forced Commutation Circuits
  • HiQ5108 Single Phase Cyclo Converter
  • HiQ5109 DC Jones Chopper
  • HiQ5110 Series Inverter
  • HiQ5111 Parallel Inverter
  • HiQ5112P 3-Phase Half Controlled Bridge Converter Power Circuit
  • HiQ5112F 3-Phase Half controlled Firing circuit
  • HiQ5113 MC-Murray Bed Ford Bridge Inverter Power Circuit  Trainer Kit

Standard accessories supplied:
4mm patch cords   -1Set
user’s manual -1Book
3pin power cord & spare fuse -1each.

Additional Equipment Requiired:

  • Isolation Transformer:

Single Phase & Three Phase
Rating: 0.5KVA, 1KVA & 2KVA

  • Regulated DC Power supply: 0-30v/5Amp.

With overload protection

  • Loading Rheostat

Rating: 0.5KW, 1.5 KW, 2.5KW & 5KW

  • Loading Inductor

Rating: 2A, 5A & 10A

  • Moving coil & Moving Iron Ammeters & Voltmeters
  • Dual Channel Differential Module
  • 20MHz/30MHz Dual Channel Analog or Digital Storage Oscilloscope
 
Home | Products | Quality | Contact us Copyright © 2006 Hi-Q Test Equipment Pvt.Ltd. Powered by www.sulekhab2b.com